b'GENERAL INFORMATION FEATURESPrecast Concrete or Fiberglass ParkUSAs PumpTrooper, a submersible pump lift station, is a reliable and cost- Models Availableeffective solution to prevent flooding by receiving and moving stormwater and/ Various Pump Types Availableor sanitary wastewater to designated locations. Generally, a lift station is used to temporally transfer liquid that cannot flow by gravity on its own. This centrifugalPedestrian or Traffic Ratedpump system is powered by a close-coupled electric motor. The pumps operateRemote Maintenance Alarm quietly and are cooled by the moving liquid to maximize their lifespan.AvailableMost pump stations are designed for duplex, triplex, or quadruplex pumpInterior Liners Availableinstallations. Although PumpTroopers can contain any number of pumps andMeets all Building Codespump sizes, the most common pump-motor unit is the duplex system. In this system, two pumps alternate in operation to equalize the wear of the pumps andParkUSAs PumpTrooper,to prevent the buildup of solids in the wet well. ParkUSAs multiple pump systema submersible pump lift station, offers continued operation in the case of a pump failure, removal for servicing, is a reliable and cost-effective and an extended capacity in times of extraordinary loading. solution to prevent flooding by receiving and moving stormwater PUMPTROOPER MODELS and/or sanitary wastewater to Effluent Pumps designated locations. Effluent pumps are used to move small quantities of stormwater or subsurface water at low to moderate flow rates. The ParkUSA line of Effluent Pump Stationis ideal for effluent applications where a gravity flow system is not practical.The effluent pump package is available in a Simplex (single pump) or Duplex(dual pump). The discharge size is typically 1 1/4 inch to 2 inches with flow ratesup to 30 gpm and horsepower ranging from fractional to two HP.Features: 1/3 HP through three HP effluent pumpsOffered as complete turnkey systems or engineered to project specificationsComputer system design and selection programs available for design assistanceVariable Wet Well SizesGrating or Hatchway AccessAutomatic or Manual Operation Grinder PumpsA grinder pump is a high-powered pump fitted with sharp cutters to shred solids and move them under high pressure usually in a relatively small diameter pipe. Grinder pumps are most commonly used for lower flows and high pressure or higher head applications. A common application where a grinder pump is used is when pumping into a pressure sewer system.Grinder Pumps are designed to disintegrate or grind the solids in wastewater thus reducing discharge pipe size and creating a pressurized system. Grinder pumps are used on small to medium sized commercial applications. The discharge pipe size is 2 inches and 3 inches, with flow rates up to 100 gpm and horsepower ranging from 2 to 7 1/5 HP.The ParkUSA line of Grinder Pump Stations is ideal for sewer applications where a gravity flow system is not practical. The grinder pump package is available in a Simplex (single pump) or Duplex (dual pump).Features: A market leader in packaged grinder pump systemsTwo HP through 15 HP grinder pumps with lifts to 260 feet and flows to 190 GPMOffered as complete turnkey systems or engineered to project specificationsComputer system design and selection programs available for design assistanceExplosion-proof construction availableNon-Clog PumpsSubmersible Non-Clog pumps are fitted with a specially designed Non-Clog impeller specifically suited for stormwater, raw and treated sewage, industrial wastes, contaminated liquids, storm and mine water, drainage, liquids containing solids in suspension, stringy material, slurries, etc. 60'