Wastewater - Division
Wastewater Diversion Systems
•Demand Driven Washdown Diversion System (DD600)
ParkUSA's Fox Demand Driven Washdown Diversion System is designed to manage water runoff from an outdoor (unroofed) equipment wash area up to 200 square feet. Drains are typically located on the wash pad where water drainage is collected. This water consists of either rainfall runoff or wastewater produced by equipment washdown operations.
The collected wastewater may contain pollutants that are harmful to the environment if released into the storm sewer system. The Washdown Diversion System is designed to route the runoff and wastewater to the proper sewer system by sensing the trigger-pull of the pressure wand or turning on the faucet. Instead, the wastewater is collected and routed to the sanitary sewer for proper treatment.
The DD 600 Washdown System is suitable for applications where the slab is left clean at the end of a washdown operation. If this cannot be assured, then the application may require a more sophisticated unit such as the FF 600 First Flush Unit.
Dolor Sit Amet
- No electricity is required
- Wash pad area roof not required
- Easy to specify, install, and maintain
- Saves on money on building construction, utilities, insurance, property taxes & maintenance.
- Avoids expensive environmental fines and protects the environment.
- Provides treatment for wash pads up to 200 SF
The Demand Driven Washdown Diversion System (DD600) consists of a drain chamber with two outlet pipes. The first is the storm sewer outlet. The second is the sanitary sewer outlet that contains a diversion valve. This diversion valve is automatic and uses water hydraulics to power the valve open or closed.
During a rain event, if no washdown is taking place, runoff is collected in the drain chamber where the level rises in the chamber where it reaches and flows out the storm sewer outlet.
During washdown operations, the diversion valve receives a hydraulic signal that the pressure washer is in use and opens. Wastewater is collected in the drain chamber and flows out to the sanitary sewer. The diversion valve will automatically close at the end of the washdown operation. This system is referred to as "demand driven". and is triggered when the water is consumed by the pressure washer equipment.
Subsequent rainfall will be drained to the storm sewer until another wash operation is used.
- Diversion Valve - 6", red brass (gunmetal) body, stainless steel shaft, nitrile rubber diaphragm & seat, discharge capability of 330 GPM @ 20" head.
- Demand Valve - 1" NPT, rated at 170 PSI, ½" drive line connection, red brass (gunmetal) body, nitrile rubber seals.
- Drainage Chamber - High density polyethylene (stainless steel optional) construction for direct burial or incorporated into precast concrete basin. Material options include Stainless Steel, Precast Concrete, or fiberglass.
- Silt Basket - High density polyethylene construction with ⅜" perforations with stainless steel handles. The unit is designed for retaining solids and is easy to remove for maintenance.
- Grating - 24" x 24" Galvanized steel grate and frame construction, hinged grate, light vehicle duty. Options include heavy duty ductile iron grates and hatchways.
- Unroofed Wash Bays
- Roofed Wash Bays subject to windblown rain
- Trash Dumpster and Compactor Drainage Area
- Car Wash and Detail Facilities
- Machinery and Workshop Washdowns
- Marinas, Slipways, and Ports
- Heavy Equipment Washdowns
- Rail Yards
- Vehicle Dealerships
- Fuel/Gas Stations
- Pet Parks and Kennels
- Livestock and Zoo Habitats
- Drilling Rigs
- Auto Parts Recyclers
- Golf Course Maintenance
- Outdoor Beach or Decontamination Showers
- IAPMO UPC IGC234 Certified and City approved
- Automated operation
- Pre-Engineered and proven technology
- Durable components providing years of usage
Solids interceptors can be used to collect and hold excessive amounts of solids substances found in wastewater. A solids interceptor should be installed in areas, as determined by the Authority Having Jurisdiction (AHJ), where pretreatment of waste streams is necessary. Some AHJs require the addition of screens or baskets that prevent solids greater than one-half inch (1/2”) in diameter from entering the sanitary sewer system. In some cases, project requirements call for even finer separation.
Solids Interceptor • The ParkUSA® SolidsTrooper® is a solids interceptor that can be used inRead more
Lint Interceptor • The ParkUSA® LintTrooper® is used in commercial and institutional laundries to removeRead more
Mud Interceptor • The ParkUSA® MudTrooper® is a sand-mud interceptor that consists of a multi-compartmentRead more
Solids Interceptor • The ParkUSA® ZooTrooper® is a solids interceptor specifically designed for animal habitatsRead more
Bag Filter Assemblies • The Bag Filter Assembly can be used to significantly reduce theRead more
Screening and grinding devices are recommended for waste water and stormwater applications where course debris and high solid concentrations occur. Screen assemblies capture unwanted floatable pollutants from entering wastewater collection and treatment systems as well as stormwater sewer systems and water bodies. Grinding applications include detention and correctional institutions where vandalism is a frequent occurrence. Inmates are known to “stuff” sheets, towels, and shoes down toilets to cause flooding of the building. The macerator grinds up these solids avoiding costly flooding and maintenance.
In-Line Grinder • The ParkUSA® Macerator Assembly is an “In-Line Grinder” system used on sewageRead more
Wastewater Screen Assembly The ParkUSA® BarScreen™ is a stationary screen device used for wastewaterRead more
Holding tanks are used when the waste stream is corrosive, toxic, flammable or heavily loaded with oxygen demanding or a public sewer system is not available. Such untreated waste can physically damage the plumbing as well as upset the wastewater treatment plant that receives the waste. Laboratories, industrial facilities, hospitals, aircraft hangar fire protection systems as well as residents, and apartment complexes are examples where holding tanks may be used.
Onsite Sewage Facilities Tank • When a public sewer system is not available, a buildingRead more
Decontamination Wastewater Holding Tank • The DeConTank® is a holding tank system solution for theRead more
Fire Fighting Foam Containment • Aqueous film-forming foam (AFFF) solution is used extensively in fireRead more
Waste Tanks • Holding tanks are typically used in commercial and industrial wastewater services whereRead more
Wastewater is water that has been adversely affected in quality by human influence and is released into a collection system. ParkUSA provides many products designed to convey, treat, store, and measure waste-water. Our products include: piping, manholes, grease/lint interceptors, oi-water, separators, pump lift stations, acid neutralization systems, decontamination systems, solids interceptors, and flume measurement systems.
Sanitary Manholes • Belowground sanitary and stormwater sewer piping require access openings by means ofRead more